OptiMate Lithium for your Triumph Lithium Battery

OptiMate Lithium 4s 0.8A

The essential Lithium battery charger for for your Triumph Motorcycles using 12V/12.8V/13.2V LiFePO4 / LFP in your road, off-road, moto-cross or race motorcycle.

Ultimate protection for your high performance Lithium battery.

Did you know, TecMate (Manufacturer of OptiMate chargers ) also produce the Triumph battery chargers! So you can be sure of the quality of the OptiMate range of chargers.

Triumph OptimMate Duo version OptiMate Lithium 0.8A
Triumph lithium and AGM / GEL /Lead acid battery charger
OptiMate Lithium for Triumph


The OptiMate Lithium 0.8A charger is also suitable for use with Triumph Motorcycles using Lithium Ion (LiFePo4) starter batteries. Your battery can be charged and maintained 24/7.

Another advantage of the OptiMate Lithium version is the BMS reset function.

This means that should your battery become flat, maybe you left the ignition on, or an accessory attached, the battery will go into self protection mode.

OptiMate Lithium is able to overcome this and reset the battery to allow it to be recovered and recharged safely!OptiMate BMS reset for Lithium starter batteries

OptiMate can charge batteries from 0.5V

save, recover, charge, maintain Lithium battery


OptiMate Lithium operates according to a fully automatic microprocessor-controlled algorithm. Once the battery is fully charged, voltage decreases to maintenance level. If any electronic accessories of the motorcycle should make battery voltage decrease below optimum charge, the equipment will automatically switch back to charging mode in order to restore proper voltage level.

We also have straight or 90 degree Triumph adapter cables to charge direct through the factory fitted accessory port. 


OptiMate Lithium Specifications:-

  • IDEAL FOR: Lithium (LiFePO4) 12.8/13.2V batteries from 1 – 10Ah
  • CHARGING AMPS: 0.8A (constant current)
  • CHARGING VOLTS: nominal: 12.8V range: 0.5V – 14.4V
  • OPERATION: Fully automatic
  • STEPS: 8
  • FEATURES: Saves low voltage LiFePO4 batteries. Specialized LiFePO4 charge cycle. Maintains & protects LiFePO4 batteries
  • USE: Indoor / Outdoor (lowest temperature: -40°F / -40°C).
  • INPUT: Global (100-240V 50-60Hz), high efficiency (CEC listed).
  • STYLE: Weatherproof case with wall mounts, with 6ft / 180cm AC supply lead and 6ft / 180cm charge lead ending in SAE connector.
  • SAVE : Low Volt Start of 0.5V + 3 step low volt save & test.
  • SAFE: No risk of overcharging. Totally safe for vehicle electronics. Sparks suppressed. Safe for long-term battery maintenance. Automatic shut-down if short-circuited or battery disconnected.
  • INCLUDED: weatherproof battery lead & battery clip set.
  • WARRANTY: 3-year limited replacement warranty.




Please note, it is not suitable for NICD, NIMH, other types of LI-ION or non-rechargeable batteries.

If your bike has a lead acid such as GEL, AGM, WET CELL, DRY CELL, you require one of our other Optimate chargers suitable for those types of battery - 


If you are looking for a higher current Lithium charger for larger Automotive Lithium starter batteries, take a look at the OptiMate Lithium 5A.

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.